Find Access Point For Computer Address Mac10/16/2021
For more information about pass phrases, see wireless security information.Note: For your wireless security settings, it is recommended that you select the WPA2 and WPA (PSK) wireless security method using TKIP and AES encryption for the most secure wireless network. For detailed instructions, consult the documentation for the networking device.Find the list of clients associated with the networking device.On the client list, find the LAN MAC address of the access point.You can find the LAN MAC address of the access point on the label on the bottom of the access point.Note the IP address associated with the LAN MAC address of the access point.In the location or address line, type the IP address of the access point and press ENTER.In the setup wizard, follow the on-screen instructions to complete the initial setup of the access point as follows:Note: If you see a “Page Not Found” error at any time while using the setup wizard, press the Back button in your Web browser or refresh the page.The setup wizard displays the SecureEasySetup page:To use SecureEasySetup to set your wireless security:Select Set wireless security using SecureEasySetup and click *Wait for setup to complete, then click Continue.To set your wireless security information manually:Clear the Set wireless security using SecureEasySetup checkbox.The setup page displays wireless security settings.Enter a Network Name (SSID), select a security Method, and enter your pass phrase. To find the IP address of the access point:Access the configuration program or configuration pages of the networking device. Find the IP Address of the Access PointThe networking device to which you connected the access point assigns IP addresses on your local network. Then you can start the setup wizard to configure the basic settings of the access point. Setup Wizard for Non-Windows UsersIf you are using an operating system other than Windows, you first need to find the IP address of the access point.If you change the wirelessSettings, be aware that for SecureEasySetup to be ready on your access point, it must be set withWPA2 and WPA (PSK) wireless security, with TKIP and AES encryption, and a pass phrase(which is also commonly called a Network key, WPA key, or WPA Pre-shared key). USRobotics recommends that you back up your settings now.In the configuration pages, click the Device tab, and scroll down to Back Up Settings.Your system prompts you to save or open the file.* By default, SecureEasySetup is ready to be used on your access point. Backing Up Your Configuration SettingsHaving a backup reduces the effort required in reapplying your configuration settings should you ever restore your access point to its factory default settings. Consider bookmarking the page for easy access to the required information.You have successfully completed the installation procedure.You can verify your network connection by registering your at To connect a client to the access point, see Connecting a Wireless Client in this user guide. If you intend to connect wireless devices to the access point manually, you will need the information on the status page. You will need it whenever you access the configuration pages of the access point.The access point displays its status page.
![]() ![]()
0 Comments
Leave a Reply.AuthorEmily ArchivesCategories |